46
Programming and Configuration Manual
7.1 ACTIVATED PROGRAMS
This functions is used to specify the programs in the program library that are to be made available to the user and in
which order the programs are to be presented on the display.
When activated, all the programs contained in the installed program library are listed.
The activated program is presented in the program selection menu. At the end of each row these programs are num-
bered in the order they are presented in the user program selection.
• NORMAL
• LOW
• NORMAL
• LOW
• NO HEATING
Note!
The programs listed depend on machine type. This example is taken from a machine with program 6A83/
6G83.
Add (activate) a program
Select the program to be added, when pressing the control knob the program will be activated. The selected program
is assigned the number after the last activated program, i.e. the selected program will be presented last in the pro-
gram selection menu.
Remove (deactivate) a program
Select the program to be removed, when pressing the control knob the program will be deactivated and renumbering
will take place automatically for the remaining programs in the list.
7.2 PARAMETER PROGRAMMING
The listed programs can be changed. The changes can be applied to all installed programs or just one individual
program.
Activate the program to be changed:
• NORMAL
• LOW
• NORMAL
• LOW
• NO HEATING
Note!
The programs listed depend on machine type. This example is taken from a machine with program 6A83/
6G83.
Parameters that can be changed
The listed parameters can be changed.
Activate the parameter to be changed:
• EXTENDED PROGRAMMING
• PRE-DRYING
• MAIN-DRYING
• END-DRYING
• COOLING
• ANTI CREASE
Note!
All parameters are shown, but in a time program only MAIN-DRYING, COOLING and ANTI CREASE are used.
To Next Page
Loading...
