Programming and Configuration Manual
49
7.4 SET START AFTER PAUSE
If a pause is programmed in a program module there is a possibility to program a time when the machine shall restart
from pause automatically.
The function use the internal RTC clock in the timer. The internal time needs to be correct in order for this function to
work. Make sure the time and date are correct. See SET TIME and SET DATE.
The programming of times is dynamic. If no occasion is set there is only two options: BACK and ADD NEW OCCASION.
When an occasion is set the start time is displayed in the menu. A square shows if the time is enable or not. (Filled
square = enable).
From the occasion list it is possible to edit or remove occasion.
It is possible to set up to ten occasions. When all ten occasions are set the line for ADD NEW OCCASION is removed
and in order to set a new occasion some occasion has to be removed.
The occasions can be activated and deactivated whenever. Deactivated occasions can be “saved” for future use if
not removed from the list.
Activate ADD NEW OCCASION to set a new occasion. For each new occasion the following menus are shown:
• ENABLED
• ALL DAYS
• MONDAY
• TUESDAY
• WEDNESDAY
• THURSDAY
• FRIDAY
• SATURDAY
• SUNDAY
• REMOVE OCCASION
ENABLED
Press the control knob to enable or disable the function. (Filled square = enable).
ALL DAYS
Press the control knob to enable or disable all days. (Filled square = enable).
MONDAY to SUNDAY
Set the days for the occasion. Press the control knob to enable or disable days. (Filled square = enable).
REMOVE OCCASION
Only valid if an occasion is set.
Activate the occasion to be removed and select REMOVE OCCASION. The occasion will be removed from the list.
7.5 RESTORE SETTINGS
If this menu is activated and saved the changes made in program parameters will be reset to the default settings from
factory.
To Next Page
Loading...
