Programming and Configuration Manual
25
4.7.2 DRYER
The following submenus are available in DRYER menu:
• ALLOW DRUM SPEED CHANGE
• ABORT PROG. DOOR OPEN
• STARTS ON DOOR CLOSING
• TIME PER COIN
• SHOW LOAD FEW ITEMS
• CHANGE TIME STEP
• POWER CTRL HEAT
• ECOPOWER STARTUP TIME
• ECOPOWER TEMP. LOW
• ECOPOWER TEMP. HIGH
• ECOPOWER EXTRA TIME
• ECOPOWER ENABLE TEMP.
• TIMEOUT, VACUUM
• RESTORE VAC.ERR. W/DOOR
• ENABLE INT. FILTER TEST
• TIME BEFORE I.F. TEST
• FAILS BEFORE I.F. MSG
• HOURS BEFORE I.F. ERR.
• VAC.ERR. PROGRAM RUN
• VAC.ERR. DRUM STOP TIME
• VAC.ERR. FAN STOP TIME
4.7.2.1 ALLOW DRUM SPEED CHANGE
This menu is only valid for machines with MCU.
Set the desired function for the sub-menu ALLOW DRUM SPEED CHANGE in the PROCESS MENU in the user interface.
ON = It is possible to activate ALLOW DRUM SPEED CHANGE during the time set in PROCESS MENU.
OFF = The sub-menu will not be displayed in the PROCESS MENU.
REGRET TIME = It is possible to activate ALLOW DRUM SPEED CHANGE during the time set in REGRET TIME.
4.7.2.2 ABORT PROG. DOOR OPEN
Not implemented.
4.7.2.3 STARTS ON DOOR CLOSING
Decide if the program shall start automatically when the door is closed both when a program is fully paid for and after
a pause.
YES = Active
NO = Not active
4.7.2.4 TIME PER COIN
Set the time for each coin.
The time is set in hours, minutes and seconds.
The pre-set value is 10 minutes.
4.7.2.5 SHOW LOAD FEW ITEMS
Set the time that the text “LOAD ONLY FEW ITEMS” shall be shown on the display.
The text is visible on the display when “Care program” has been selected.
The time is set in seconds.
The pre-set value is 5 seconds.
To Next Page
Loading...
