28
Programming and Configuration Manual
4.7.2.21 VAC. ERR. FAN STOP TIME
Set the time for fan stop if vacuum is lost during program run.
The pre-set value is 10 seconds.
4.8 CONFIG. 2
Activate the CONFIG. 2 menu.
A password is needed to continue. The display will now show an eight figure code. Call authorized service and state
the code. Authorized service will assign a pass code. Enter the pass code you have been given and press the control
knob.
Activate the relevant sub-menu.
The sub-menus are divided into different sections, COMMON and DRYER.
In COMMON all parameters valid for both washer extractors and tumble dryers are listed.
In DRYER all parameters valid only for tumble dryers are listed.
To Next Page
Loading...
