Programming and Configuration Manual
19
4.7.1.1 PROCESS MENU TIME
The PROCESS MENU is the menu that appears on the display when pressing the control knob (start button on ma-
chines without control knob) in the user interface during operation.
Set the time that it is possible to activate the PROCESS MENU during a program run.
Default value is set to 24 hours, which means that it always is possible to activate the menu.
If for example the time is set to 10 minutes it is only possible to activate the menu during the 10 first minutes of a pro-
gram run.
The time can be set in hours, minutes and seconds.
4.7.1.2 INACTIVE TIMEOUT
Set the time that the PROCESS MENU will be displayed before disappearing if inactive.
The time can be set in hours, minutes and seconds.
4.7.1.3 REGRET TIME
Set the time that some menus will be displayed for in the PROCESS MENU before disappearing.
When regret time is up the function will be blocked.
For example: Pause function shall only be possible during the 10 first minutes of the program run = Set the time to 10
minutes.
The time can be set in hours, minutes and seconds.
4.7.1.4 PAUSE PERMITTED
Set the desired function for the sub-menu PAUSE in the PROCESS MENU in the user interface.
ON = It is possible to activate PAUSE during the time set in PROCESS MENU.
OFF = The sub-menu will not be displayed in the PROCESS MENU.
REGRET TIME = It is possible to activate PAUSE during the time set in REGRET TIME.
4.7.1.5 PAUSE TIME
Set the maximum time a program can be paused before it is aborted.
The time can be set in hours, minutes and seconds.
4.7.1.6 NEW PROG. SELECT
Set the desired function for the sub-menu CHANGE PROGRAM in the PROCESS MENU in the user interface.
ON = It is possible to activate CHANGE PROGRAM during the time set in PROCESS MENU.
OFF = The sub-menu will not be displayed in the PROCESS MENU.
REGRET TIME = It is possible to activate CHANGE PROGRAM during the time set in REGRET TIME.
4.7.1.7 ABORT PROG. ALLOW
Set the desired function for the sub-menu END PROGRAM in the PROCESS MENU in the user interface.
ON = It is possible to activate END PROGRAM during the time set in PROCESS MENU.
OFF = The sub-menu will not be displayed in the PROCESS MENU.
REGRET TIME = It is possible to activate END PROGRAM during the time set in REGRET TIME.
4.7.1.8 SHOW STATISTICS
Set the desired function for the sub-menu STATISTICS in the PROCESS MENU in the user interface.
ON = It is possible to activate STATISTICS during the time set in PROCESS MENU.
OFF = The sub-menu will not be displayed in the PROCESS MENU.
REGRET TIME = It is possible to activate STATISTICS during the time set in REGRET TIME.
To Next Page
Loading...
