72
ATTENTION
If the machine is to be installed in places with
low ceilings (2100 mm), the feet should be re-
placed with lower ones, available to order (kit
code 880326-no.4 feet H67-80).
ATTENTION
Wait at least 2 hours before starting the appli-
ance, to allow the oil to ow back into the com-
pressor.
There must be free air circulation above the
appliance, at the refrigerating unit. There must
be no obstructions caused by trays, cardboard
boxes, jars or other materials (see par. C.1.2.2).
wear protective gloves and unpack the machine, carrying
out the following operations:
- cut the straps and remove the protective lm, taking care
not to scratch the surface if scissors or blades are used;
- remove the cardboard top, the polystyrene corners and
the vertical protection pieces.
For appliances with stainless steel cabinet, remove the protec-
tive lm very slowly without tearing it, to avoid leaving glue
stuck to the surface.
Should this happen, remove the traces of glue with a non-cor-
rosive solvent, rinsing it o and drying thoroughly; it is advisable
to go over all the stainless steel surfaces with a rag soaked in
paran oil in order to create a protective lm.
B.2.4 Disposal of packing
The packing must be disposed of in compliance with the cur-
rent regulations in the country where the appliance is used.
All the packing materials are environmentally friendly. They can
be safely kept, recycled or burned in an appropriate waste in-
cineration plant. Recyclable plastic parts are marked as follows:
To Next Page
Loading...
