Electrolux Prostore PS06R1F - Replacing the Power Cable; Quick Troubleshooting Guide

90

Condenser 600mm freezer model:

Condenser 900mm refrigerated model:

Condenser 900mm freezer model:
D.1.2.2 Replacing the power cable
To replace the power cable, proceed as follows:

disconnect the power supply;

undo the control panel xing screws;

lift the control panel and make sure it is locked (it is ad-
visable to x it with adhesive tape);

remove the electrical box plastic cover;

replace the power cable;

ret the electrical box plastic cover and lower the con-
trol panel;

retighten the control panel xing screws;

reconnect the power supply.
D.1.2.3 Quick troubleshooting guide
In some cases, faults can be eliminated easily and quickly by
following a brief troubleshooting guide:
A. The appliance does not switch on:

make sure the plug is properly inserted in power socket.

make sure the socket is powered.
B. The inside temperature is too high:

check the thermostat setting;

make sure there is no heat source near the appliance;

make sure the door closes properly.
C. The appliance is too noisy:

make sure the appliance is properly levelled.
An unbalanced position can set o vibrations.

make sure the appliance is not touching other equipment
or parts which could reverberate.
If the fault persists after carrying out the above checks, contact
the After-Sales Service, remembering to specify:

the type of fault;

the appliance PNC (production number code);

the Ser. No. (appliance serial number).
Note: The code and serial number are essential for iden-
tifying the type of appliance and date of manufacture:
appliance identication code
fourth digit of the year
of production (2014)
third digit of the year
of production (2014)
week 14
10th piece
manufactured
in the week
Ser. No. 4 14 1 0010
PNC
691199 00