6
Configuration of control panel
The washing programmes, the functions of the selector knob and the various pushbuttons vary
according to the model, since these are determined by the configuration of the appliance.
Programme selector (S1)
The selector features 16 positions and incorporates the ON/OFF switch.
The various positions of the selector may be configured to perform
different washing programmes; in the first position, the appliance is
switched off and the current programme is cancelled. For each
programme, the compatible options and other parameters are defined.
• Programme configuration
The table below lists the parameters that can be used to define the washing programmes.
Types of fabric
Cotton/linen, Synthetic fabrics, Delicates, Wool, Hand-wash
Special programmes
Soak, Rinses, Spin, Drain, Conditioner
Temperature
Normal, Maximum: the initial temperature is the maximum that
can be selected for a specific washing programme
Spin
Normal, Minimum, Maximum
Options (Normal / Possible)
Bleach, Economy (energy label), Stains, Short, Very short,
Reduced spin speed, Night-time cycle, Half-load, Easy-Iron,
Rinse Hold, Extra rinse, Pre-wash
Programme phases
Pre-wash, Wash, Rinses, Spin, Economy, Delayed start
Secondary selector (S2)
Certain models may also feature a 6-position secondary selector. The
function of this selector is defined during configuration of the
appliance
• Temperature selector: each position corresponds to a
temperature or to the cold wash cycle.
• Spin speed selector: at each position, it is possible to select a
spin speed that is compatible with the programme. In the final
positions, the following options can also be configured: No Spin,
Rinse Hold, Night cycle.
To Next Page
Loading...
