To Next Page

To Previous Page

visual centerline to the middle of the instrument. The pilot’s visual centerline is a perpendicular line from the

pilot’s eye to the instrument panel. In most aircraft, installing the MVP-50P to the right of the radio stack

would be acceptable. In some aircraft, the visual centerline falls to the right of the Attitude Indicator.

If the powerplant instrument cannot be installed within 8" of the pilot’s visual centerline, AC 23.1311-1B

recommends Master Caution and Warning Lights be installed. Installation of Master Caution and Warning

Lights is covered in this manual.

Installing the MVP-50P may require an instrument (or two) to be moved to a new location. The MVP-50P

replaces eight or more primary instruments in the aircraft instrument panel, therefore moving an instrument to a

new location may not be an issue. If the installer is unwilling or unable to find a location for the MVP-50P,

DoDo

Not InstallNot Install

Not Install the MVP-50P. The system may be returned for a refund (contact EI for more information).

2.5 Install the Temperature Probes:

Install only the Temperature Probes applicable for your configuration.

A. A.

EGT Probe Installation:EGT Probe Installation:

EGT Probe Installation:

Look at each exhaust stack and determine the best location at which all of the EGT probes can be mounted

at the same distance down from the exhaust ports. The ideal location is 1 1/2", but ease of installation should

prevail. For our fast responce probes drill a 5/32 hole or for our robust probes drill a 13/64" diameter hole in

each exhaust stack. Insert the probe and tighten the hose clamp. As the hose clamp is heated and cooled, it

will become loose as it conforms to the exhaust stack. After the first 10 hours of operation, each hose clamp

should be retightened.

IMPORTANT NOTE: For Cessna 210s or any aircraft having a slip joint in the exhaust system, install the

EGT probes ABOVE OR BELOW THE SLIP JOINT. Installing an EGT probe in the slip joint can damage

the probe.

P-110 Hose Clamp, Type K.

Used on most engines.

(Red)

(Yel)

To EDC

Temp Input

(Middle or Bottom

Connector)

Electronics International MVP-50P Installation Instructions

Other manuals for Electronics International MVP-50P