Contents
(Page 1 of 3)
Warranty/Agreement-------------------------------------------------------------------------------------- 1A
1.0 System Overview ------------------------------------------------------------------------------------- 2
1.1 MVP Description ------------------------------------------------------------------------------ 4
1.1.1 MVP Display ---------------------------------------------------------------------------- 4
1.1.2 EDC-33P --------------------------------------------------------------------------------- 4
1.1.3 Probes, Transducers and Modules --------------------------------------------------- 5
1.1.4 Wiring & Extension Cables ----------------------------------------------------------- 5
1.2 Operational Overview ------------------------------------------------------------------------------- 5
1.3 Installation Overview --------------------------------------------------------------------------------- 5
1.4 Password Protection ---------------------------------------------------------------------------------- 6
1.4.1 Level #1 Password (Maintenance) ------------------------------------------------------- 6
1.4.2 Level #2 Password (OEM) ---------------------------------------------------------------- 7
2.0 Hardware Installation -------------------------------------------------------------------------------- 9
2.1 Important Information and Initial Check Out: ------------------------------------------- 11
2.2 Review the "EDC Wiring Work Sheet:" -------------------------------------------------- 12
2.3 Verify you have all the necessary Probes, Modules, Transducers and Cables: ----- 12
2.4 Install the MVP Display: --------------------------------------------------------------------- 12
2.5 Install the Temperature Probes: ------------------------------------------------------------- 13
2.6 Install the Pressure Transducers: ----------------------------------------------------------- 15
2.7 Install the Interface Circuit for Annunciators -------------------------------------------- 19
2.8 Install the Interface Circuit for a PWM Backlight System (Optional): --------------- 19
2.9 Install the Interface Circuit for Flaps and Trim ------------------------------------------ 20
2.10 Install the Interface Circuit for the Gear Position, Unsafe Indicator and Gear --- 20
2.11 Install the CO-Guardian CO Detector -------------------------------------------------- 21
2.12 Install the Shunt: ----------------------------------------------------------------------------- 21
2.13 Install the Fuel Flow Transducer: --------------------------------------------------------- 24
2.14 Install the P-300C Fuel Level Probes (OEM or Experimental) --------------------- 30
2.15 Install the P-300M Fuel Levl Sender: ---------------------------------------------------- 30
2.16 Install the Resistive Fuel Level Module (RFLM-4-X): -------------------------------- 31
2.17 Install the Voice Alarm Control Panel (OEM or Experimental): ------------------- 31
2.18 Install the Intensity Control Pot (Optional): -------------------------------------------- 31
2.19 Install the Master Warning (red) and Caution (yellow) Lights: ----------------------- 32
2.20 Install the USB-6A (Optional): -------------------------------------------------- 32
2.21 Install the FM-SC or AC-1 Converter (Optional): ------------------------------- 32
2.22 Install any Additional Modules (Optional): -------------------------------------- 32
2.23 Install the EDC-33P: ------------------------------------------------------------------------ 32
To Next Page
Loading...
Need help?
General
