3.03.0
3.03.0
3.0
Install the EDC Wire HarnessesInstall the EDC Wire Harnesses
Install the EDC Wire HarnessesInstall the EDC Wire Harnesses
Install the EDC Wire Harnesses
andand
andand
and
Route WiresRoute Wires
Route WiresRoute Wires
Route Wires
3.1 Attach the three EDC 37-pin Wire Harnesses to the EDC:
3.2 Connect the EDC Harness to the Temperature Probes:
3.3 Connect the EDC Harness to the Pressure Transducers:
3.4 Connect the EDC Harness to the Shunt:
3.5 Connect the EDC Harness to the Fuel Flow Transducer:
3.6 Connect the EDC Harness to the Existing Capacitive Fuel Level System:
3.7 Connect the RFLM-4-x Harness to the EDC Connector and to the Resistive Fuel
Level Sensors:
3.8 Connect the EDC Harness to the EI P-300C Capacitive Fuel Level Probes:
3.9 Connect the EDC Harness to the EI P-300M Magnetic Fuel Level Senders:
3.10 Connect the EDC Harness (Volts Measurement Pin) to the Bus:
3.11 Connect the EDC Harness to the RPM Signals:
3.12 Set up the EDC for a 4 or 6-Cylinder Engine:
3.13 Connect the EDC Harness to the VI-221's (Voltage Interface Units):
3.14 Connect the EDC Harness to Power and Ground:
3.15 Route the EDC RS422 Wires to the MVP Connector:
33
To Next Page
Loading...
Need help?
General
