Electronics International MVP-50P Installation Instructions

71
a) Action: Check that the voltage on the appropriate EDC pin changes from high to low and
back to high as the Annunciator is cycled.
2. Problem: The MVP is set up incorrectly.
a) Action: Check the "Start" and "End" setting in the “4. Redlines, Limits and Color Setup”
screen.
Check the probe selected in the “1. EDC Input to Function Mapping” screen is
"Volts 0-2.5."

Electronics International MVP-50P Specifications

General

Brand	Electronics International
Model	MVP-50P
Category	Monitor
Language	English