Elektron Digitakt - Page 39

10. THE SEQUENCER
39
2. Press and hold [PTN] and then press a [TRIG 1–16] key to select the first pattern in the chain.
3. Release the [PTN] key and then press [TRIG 1–16] keys in the same order as you want the chained
patterns to play. Keep a previous [TRIG] key pressed while you press the next one, the one after that
and so on. You can press the same [TRIG] key again if you wish to add the pattern multiple times in a
row. If you want to add a pattern from another bank, press [BANK] + [TRIG 9–16] to select bank, and
then press [TRIG 1–16] to select pattern.
4. Press [PLAY] to start the sequencer and play the chain. The chain will be looped once the final pat-
tern of the chain has played.
Please note that the chain will be lost when you create a new chain or when you select a new
bank/pattern. Chains cannot be saved and will be lost when you switch the Digitakt o.
• Chains can be created while the sequencer is running.
• You can also use MIDI program change messages from an external device to change
patterns on the Digitakt. For more information, please see “15.3.1 SYNC” on page 64.