Elektron Digitakt - Settings Menu

15. SETTINGS MENU
60
15. SETTINGS MENU
The SETTINGS menu oers settings that aect Digitakt and can also be used to manage Projects.
Press [GLOBAL SETTINGS] to access the SETTINGS menu. Scroll the list by using [UP]/[DOWN] or the
LEVEL/DATA knob. Open a highlighted menu by pressing [YES].
15.1 PROJECT
15.1.1 LOAD PROJECT
Load Project opens a project selection screen where you can choose a project to load. Note that the ac-
tive project will not be saved before loading the new project so remember to save the active project first.
If you wish to create a new project, select CREATE NEW at the very bottom of the list. The new project
will be a blank slate.
If you load a new project it will replace the active project. Be sure to save your active
project before you load another project.
15.1.2 SAVE PROJECT AS
Save Project opens a project selection screen where you choose a slot to save the active project to.
You can also press [FUNC] + [GLOBAL SETTINGS] to access this screen.
15.1.3 MANAGE PROJECTS
Manage Projects launches the PROJECT MANAGER menu. Selecting a project in this menu and pressing
the [RIGHT] arrow key will bring up a list of commands.
• CLEAR Resets the project slot to a clean state.
• DELETE Removes the project from the slot.
• RENAME Opens a NAMING screen where you can rename the project file.
• LOAD FROM Loads the selected project. This will replace the active project!
• SAVE TO Saves the active project to the selected slot.
• TOGGLE Toggles write protection on or o. Write protected projects cannot be overwritten, re-
named or erased. A lock symbols in front of the project name shows that the project is write protected.
• INIT NEW Initializes an empty file slot with a clean project. This option is only available for empty
project slots.
• PURGE ALL purges (removes) all Sounds from the Sound pool and all samples that are not used in
any pattern in the project from the RAM memory. The Sounds and samples are not removed from the
+Drive Sound library. This option is only available when you select the currently loaded project.