EasyManua.ls Logo

Element4 SKY Series - Decorative Ceramic Parts Arrangement; Decoration Arrangement Guide

Default Icon
39 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
Chapter 10
INSTALLATION MANUAL |
Figure 9.1 | Logset decoration instruction
An elaborate decoration instruction is found on the sheet in the logset
that comes with the re. These instructions show you how to decorate
the re step by step.
Position the decoration logs as shown on the image below.
Make sure that the pilot ame area and the second thermocouple are
always free of any decorative material to make certain that the re will
ignite without problems. Not doing so may cause the re to explode on
ignition!
10 DECORATIVE (CERAMIC) PARTS
This appliance is equipped with a ceramic re bed with heat-resistant
ceramic bers, or articial glassy silicate bers. Excessive exposure to
this material may cause irritation to the eyes, skin and respiratory tract.
We therefore recommend that the dust emission is reduced as much as
possible when handling these materials.
10�1 DECORATION ARRANGEMENT
Only the decoration ceramics supplied with this appliance are to be
used. The ceramics must be laid only as shown on this page. Replacement
parts are available from your dealer, but should only be installed by a
qualied installation engineer.

Table of Contents

Related product manuals