EasyManuals Logo

Elmo TT-12 User Manual

Elmo TT-12
87 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
vi
English
BEFORE YOU USE
Be sure to use the power cord and the AC adapter attached to this product.
Be sure to use the power cord applicable to your local power specifications. If the product was sold in Japan,
use the AC adapter sold with the product with 100 VAC and 50 or 60 Hz.
When storing the product, do not leave it under direct sunlight or by heaters. It may become discolored,
deformed, or damaged
.
Do not place this product in an
y humid, dusty, salt bearing wind, or vibrating locations.
Only use it under the following environmental conditions:
Temperature: 0°C - 40°C (32°F - 104°F)
Humidity: 30% - 85% (No condensation)
Use a soft, dry cloth for cleaning.
Do not use any volatile solvent such as thinner or benzene.
Do not point the camera lens directly at the sun. It may be damaged and yo
u may not be able to take pictures.
Luminescent and Black Spots
There may be some pixels that do not properly operate due to the use of CMOS Area Image Sensors made-up
of many pixels.
Though luminescent or black spots may be found on the screen, it is a phenomenon peculiar to the CMOS Area
Image Sensors and is not a malfunction.
Follow the guidelines below to prevent the unit from dropping or ov
erturning.
Use
the product on a stable base, desk, or table. Do not place the product on an unstable base or slanted
surface.
Place or wire the unit to prevent the AC adapter cord or video cable from pulling.
Carry the product by holding the lower part of the main unit in both hands. Never hold the product by the
column or the camera head.
Pay careful attention when using (including setting-up
and storing) or transferring the product to prevent the
camera head from receiving an
y shocks.
Do not look directly into the LED light. If you look directly into it at point-blank range, your eyes may be injured.
Some type of SD card/USB flash drive can be used.
Transfer the data from the SD card onto a device such as a PC to save a backup copy. Malfunction of the
product or repairs to it may c
ause the data saved in the SD card to be deleted.
If this product is used for longer than the warranty period, its performance and quality may deteriorate due
to the lifetime of its parts. To purchase replacement parts, consult the dealer from whom you purchased this
product or our branch/office near your location.
Battery precautions:
If this product is not going to be used for a long time, ta
ke the batteries out of the remote control.
Do not use rechargeab
le batteries (e.g., Ni-Cd (NiCad batteries)).
Do not use new and old batteries or batteries of different types together.
Do not try to recharge or short-circuit the batteries.
When disposing of used batteries, follow the instructions of your local government.
Insert from one side and pay particular attention to the polarity (+/- directions).
Be sure to use AAA batter
ies.
If any liquid from a battery leaks onto your skin or clothes, flush the area with clean water immediately. If it gets
into your eye, flush immediately with clean water and then contact a doctor.

Table of Contents

Other manuals for Elmo TT-12

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Elmo TT-12 and is the answer not in the manual?

Elmo TT-12 Specifications

General IconGeneral
Optical Zoom12x
Digital Zoom8x
Frame Rate30 fps
FocusAuto/Manual
ApertureF3.2
InterfaceUSB 2.0
CompatibilityWindows, macOS
OutputHDMI, USB
LightingLED
Resolution1920 x 1080 (Full HD)

Related product manuals