18
Threading the Machine
Raise the presser foot with the presser foot lever.
Hand turn the flywheel (always turn towards you)
to bring the needle up to its highest position.
Using both hands, pull thread towards left and
insert thread into slit. firmly insert the thread under
the thread guide plate .
Pull thread foward around guide . (Thread
pathway is indicated on the machine with solid
line.)
Guide the thread down right channel and around
the thread holder .
Pull the thread up the left channel to the take-up
lever. Firmly pull the thread from right to left, over
the take-up lever and down into the take-up lever
eye r.
Proceed down left channel and through the lower
thread guide t.
Slide the thread to the left behind the needle bar
thread guide y.
Thread the needle from front to back manually or
use the built-in needle threader. See page 19.
4
21
3
q
w
e
e
t
y
r
q
w
To Next Page
Loading...
