19
Built-in Needle Threader
Hand turn the flywheel (always turn towards you)
to bring the needle up to its highest position. Turn
OFF the power switch. Lower the presser foot.
Pull down the needle threader lever q as far as it
will go. Hook
w is automatically inserted into the
needle eye.
Bring the thread around guide e and under hook
w.
Slowly release the lever while holding the thread
end and let the needle threader return to its
original position. A loop of thread r is pulled
through the needle eye.
Pull the thread loop off the guide to the back and
manually bring the thread through the needle eye.
NOTE: The needle threader can be used with #11
to #16 size needles. Thread weight may vary from
30 to 90.
If the needle threader does not catch a thread
loop, check the needle and positioning.
q
w
e
w
r
To Next Page
Loading...
