ELNA 8200 - Sewing a Single Built-in Design

28
Edit
Mode
1 2 3 4
5 6 7 8
Designs
Hoop Size A(F): 126 X 110 mm
A Z
START
STOP
Edit
Mode
1
2
3 4
Ready to Sew
A Z
Size
P
A(F): 126x110mm
Jog
ST
2
1
30 min
5 colors
109x84mm
5597
5776
5802
5757
Snow
White
Seashell
GS
Gray
Green
Dust
Sewing a Single Built-in Design
Select a design.
Touch “Return” key in the hoop size warning
message.
Hoop fabric and attach hoop to carriage. Position
needle directly over centerlines on fabric. Thread
machine with first thread color. Lower presser foot.
Press “Start/Stop” key and sew 5 or 6 stitches.
Stop machine by pressing “Start/Stop” key.
Raise presser foot. Cut away beginning thread tail
close to the start point. Lower presser foot.
Press the “Start/Stop” key and let the machine sew
until it stops automatically for the thread change.
Sew entire design using method described above
for each thread change.
When design is finished, the word “Completed” will
appear. Touch the “Return” key.
The design should be aligned with the centerlines
on the fabric.
HINT: You can check the design positioning before
sewing with the tracing key or template sheets.