36
Commissioning
If a device is brought from a cold to a warm area, condensation
can form. Before starting the device up, please ensure there is
no moisture inside it (if necessary leave to dry).
After the system has been wired and the connections have been checked, please
proceed as follows:
• Switch on the power supply voltage of the weather station.
• Insert batteries in the operating unit as described in chapter “Insert
batteries”.
• The display of the operating unit now indicates that the radio connection
between weather station and operating unit is not taught in.
• Press
key for 3 seconds until the following display appears:
• Press again for 3 seconds until the display for the teaching in of the radio
connection appears.
To Next Page
Loading...