4
The following environmental parameters are measured and displayed:
• Outdoor and indoor temperature
• Lightness
• Wind speed
• Precipitation
Solexa may be deployed in the control system XS as control centre and as
transducer. In this case, the control is upgraded with motor control units and
operating units of system XS.
The patio roof control Lixa may as well be programmed with the Solexa. The
awning connected to Lixa will then follow the shading automation of Solexa.
Overview of available automatic functions
• Shading according to sun intensity with extension and retraction delay
• Extension to a programmed position; for blinds with slats with additional
setting of the slat angle.
• Blocking of shading until a selectable indoor temperature is reached (heat
gain, only in automatic mode)
• Retraction of shading below a selectable outdoor temperature (frost
protection, only in automatic mode)
• Retraction of shading when a selectable wind speed is reached (wind alarm,
function may be deactivated)
• Retraction of shading in case of rain (rain alarm, function may be
deactivated)
The awning or blind is retracted in automatic mode after the set lightness value
falls below or in case of rain/wind alarm.
The wind and rain protection functions are also active in manual mode if they
have been set in automatic.
To Next Page
Loading...