ELTEX TAU-8.IP - Page 46

46 VoIP Subscriber Gateways
 Secret phrase – encryption key is a string with length from 8 to 63 ASCII symbols;
 Secret WPA key (Key) – set key with 64 characters of hexadecimal number system;
- Authorization on a RADIUS-server – when checked, use authorization on a RADIUS-
server. When the parameter is selected, the following settings will be available for
editing:
 Server Address – domain name or IPv4 address of authorization server;
 Server Port – server port for authorization;
 Secret key – secret key for access to server of authorization;
 Authentication algorithm – select authorization algorithm (MSCHAPv2, MSCHAP,
CHAP, PAP).
Username for client authentication on RADIUS server is equal to its MAC address
(lowercase letter without separator symbols between bytes) and key of RADIUS server is
used as password.
- Replication of multicast traffic – enable replication mode for multicast traffic. When this
parameter is selected, the following configuration will be available:
 Maximum count of errors – max count of transmission errors upon the exceeding of
which it is considered that the user out of network range. It is used to disable users
in the replication mode of multicast traffic;
- Show advanced settings – when checked, configuring the addition settings are available
from the following list:
 HT40+ – when checked, merge mode of two 20 MHz channels into 40 MHz channel
is enabled (the first channel is over the second, it operates only for 1-9 channels);
 HT40- – when checked , merge mode of two 20 MHz channels into 40 MHz channel
(the second is over the first, it operates only for 5-11 channels);
 LDPC support – when checked, support of coding with low-density parity-check
code is enabled;
 SMPS - Static – when checked, Spatial Multiplexing Power Save Static method is
available;