EasyManua.ls Logo

ELTEX TAU-8.IP - Page 47

ELTEX TAU-8.IP
190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
47 VoIP Subscriber Gateways
SMPS - Dynamic when checked, Spatial Multiplexing Power Save Dynamic method
is available;
Green Field when checked, compatibility with IEEE 802.11b/g;
Delayed Block Ack when checked, delayed data block acknowledgment mode is
enabled, otherwise immediate acknowledgment is used;
Set A-MSDU to 7935 octets when checked, max size of A-MSDU is 7935 bytes
otherwise it is 3839 bytes;
DSSS/CCK mode (for 40 MHz) when checked, DSSS/CCK modulation operation
mode is used;
PSMP support when checked, Power Save Multi-Poll will be used for down town;
L-SIG TXOP support when checked, L-SIG TXOP method of combined protection for
data transmission (802.11n) is used;
STBC support at reception (1 stream) (RX-STBC1), STBC support at reception (up to
2 streams) (RX-STBC2), STBC support at reception (up to 3 streams) (RX-STBC123)
when checked, signal reception with supporting STBC (space time block codes)
encryption is enabled;
TX-STBC when checked, data encryption is used to improve signal-to-noise ratio;
Short guard interval (20 MHz) (SHORT-GI-20) when checked, guard interval for 20
MHz operation mode is equal to 400 ns (data speed is up to 150 Mbps), otherwise-
800 ns (data speed is up to 130 Mbps);
Short guard interval (40 MHz) (SHORT-GI-40) when checked, guard interval for 40
MHz operation mode is equal to 400 ns (data speed is up to 300 Mbps), otherwise-
800 ns (data speed is up to 270 Mbps);
WMM Wi-Fi Multimedia (WMM) operation mode setting. This operation mode
allows you to quickly and efficiently transmit audio- and video content
simultaneously with data transmission.
To store changes to the operative memory of the device, click the Save Changes button. To store
settings into the non-volatile memory, click Apply button.
The DHCP Server submenu
The submenu is available only for TAU-8.IP-W devices.
In the DHCP server submenu, you may configure a local DHCP server.
DHCP (Dynamic Host Configuration Protocol) automatically assigns IP addresses to the
computers. DHCP eliminates limitations associated with the manual TCP/IP protocol configuration.

Table of Contents

Other manuals for ELTEX TAU-8.IP

Related product manuals