Driver Board Introduction
Figure 3-1 PS2X&Motor Driver Board Introduction
Common problems
Q：How to power the PS2X&Motor Driver Board?
A：It can be directly powered by the DC port of Arduino UNO. The voltage range is 6~12V and the
current is 500mA~2A. Or PH2.0 wiring port power supply, the voltage range is 6~12V, there is a power
supply jumper cap on the drive board, you need to short circuit the IN and 5V.
Q：How many motors does the PS2X&Motor Driver Board can drive？
A：The PS2X&Motor Driver Board can drive 4 DC motors ,2 stepper motors or 2 encoder motors.
Q：How does PS2X&Motor Driver Board connect power drive servo？
A：PS2X&Motor Driver Board has D5, D6 two interfaces for external power drive servo.
To Next Page
Loading...