Emax TINYHAWK III Quick Start Guide

Binding Procedure
Binding is the process of uniquely associating a particular receiver to a transmitter module.
A transmitter
module can be bound to multiple receivers (not to be used simultaneously). A receiver can
only be bound to one transmitter module.
1.Hold the bind button while powering on the receiver. When the BLUE LED is on, it means
the receiver is in BIND MODE
2.Turn on the transmitter, make sure it is set to D8 mode, and then set it into bind status.
When the BLUE LED of the receiver starts flashing, it means bind successful.
3.Turn on the transmitter again, the BLUE LED receiver will be on, it means the receiver is
receiving data from transmitter. Transmitter bind with receiver no need repetitive operation,
unless you change either receiver or transmitter.
The receiver can be instructed to enter the binding mode through the Betaflight
configurator. Type the following command in the CLI tab: bind_rx
Click the Enter key, your receiver will enter the binding mode, and then follow the binding
steps 2 and 3 to complete the binding process.

Emax TINYHAWK III Specifications

General

Brand	Emax
Model	TINYHAWK III
Category	Quadcopters
Language	English