Emax TINYHAWK III - Tinyhawk III Propeller; 3.1 Tinyhawk III Components; 3.2 Propeller Installation and Removal

Unlock
Arming refers to setting Tinyhawk III to begin flying. When Tinyhawk III is powered on for
the first time, it will not spin the propeller until it is armed.
1. First move the throttle to the bottom position to control the aircraft,
2. Then move the left switch of the E8 Transmitter to the third position.
When Tinyhawk III is successfully armed, you will see the propellers spinning.
Note: In the event of a collision, Tinyhawk III must stop flying immediately. Failure to stop
the flight in time will damage Tinyhawk III. Before handling Tinyhawk III, be sure to switch
the switch to an unarmed position.