Adjusting Software Settings (Betaflight Configurator)
Betaflight Configurator can be used to changed programmed settings on Tinyhawk III.
Betaflight Configurator and flight controller firmware can be downloaded at
https://github.com/betaflight/. The hardware target for Tinyhawk Flight Controller is
MatekF411
DISCLAIMER:
We do not suggest changing any PID settings on TinyhawkIII or upgrading the firmware to
new versions. Tinyhawk III comes stock with an optimal tune for proper flight performance.
Changing this can affect flight time, overall speed, control of the aircraft, and excessive heat
within the motors.
Reprogramming Tinyhawk Flight Controller
Put the Flight Controller in DFU mode by pressing the BOOT button while plugging in the
micro USB cable to a computer.
Select STM32F411 as the target and then select the firmware . Select Manual Baud Rate with
256000 in the drop down menu
Select Load Firmware(Online) to download the firmware
Select Flash Firmware to program the flight controller
To Next Page
Loading...
Need help?
General
