EMC VNX Series Hardware Information Guide

System component description
EMC VNX8000 Hardware Information Guide 17
SPE front view
The front of the VNX8000 platform 4U SPE shows four hard drives with two LEDs per drive
(power and fault), five fan modules with one LED per module (fault), four power supplies
with three LEDs per power supply (AC, DC and DC fault). Four status LEDs per SP: one SP
power on, one SP chassis (enclosure) fault, one SP fault, and one SP unsafe to remove.
Figure 6 Example of SP components (front view)
1 Latch (orange) for SP B (one per SP);
push down to unlock SP from SPE
chassis
6 SP A fan module push tabs (push together
to unlock fan), then pull out to release
2 Lock latch handle (black) for SP B (one
per SP); after unlocking with the
orange latch (see location 1), pull the
black latch handle horizontally across
the top to release the SP from the SPE
chassis
7 SP A fan module
3 SP B hard drive slot (not used at this
time)
8 SP A fan fault icon for fault LED (10 places)
4 SP A power supply Detail
1
SP A status LEDs; SP power on (blue), SP
chassis (enclosure) fault (amber), SP fault
(blue/amber), and SP unsafe to remove
(white)
Note: On the inner right side (around the
corner) of the SP, LED labels for the SP and
the SP chassis (enclosure) are shown.
5 SP B power supply recessed
connectors (plugs); two per SP (one
gray and one black)
Detail
2
SP A power supply LEDs; AC, DC and fault
(labeled with !)
3
1
2
567
SP power on
SP chassis fault
SP fault
SP unsafe to remove
Detail 1
8
AC
!
DC
AC
!
DC
AC
!
DC
AC
!
DC
Detail 2
AC
DC
!
4
VNX-000566

EMC VNX Series Specifications

General

Management Interface	Unisphere
Drive Support	SAS, NL-SAS, Flash (SSD)
RAID Levels	RAID 0, 1, 3, 5, 6
Protocols Supported	Fibre Channel, iSCSI, NFS, CIFS
Data Services	Deduplication, Compression, Snapshots, Replication
Processor	Intel Xeon
Operating System	VNX Operating Environment (block), VNX File Operating Environment (file)