DPSI BMS Operating Manual Version 1.0
Page 27 of 32
After selecting the battery-2
activation / deactivation, the new
configuration is saved and the
DPSI BMS is restarted after an
internal reset.
12. Safety Instructions
In general, all connection cables should not be installed in a way
that they interfere with moving or hot parts in the model (e.g.
servos, servo wires or mufflers).
Protect the DPSI BMS from wetness and humidity.
Improper usage of the DPSI BMS can cause severe property
damage or personal injury!
Always double check all connections in your model before any
usage! All connections must be of the correct polarity, have a
clean contact and be secured. Loose cables pose a potential
hazard!
Under no circumstances use power sources which exceed the
denoted voltages.
Current leading contacts must not be shorted. Otherwise shorted
cables can heat up or even melt.
The DPSI BMS must not, under any circumstances, be taken
apart or technically altered. There are no parts at all within the
DPSI BMS, which could be maintained or repaired by the user.
Never use the DPSI BMS for reasons other than for RC modeling
in the hobby area. Especially the application in manned machines
is specifically prohibited.
To Next Page
Loading...
