Auto Sweep
Auto SweepFigure 4-2:
a. Position the laser and sensor at a starting angle (any angle). Make sure
the laser and sensor are within 2° of each other. The position of the
laser fixtures is marked on the screen with a black line on the green
circle.
If the laser and sensor angles are not within 2° of each other, the
background of the circle is white. The starting angular position of the
laser fixtures is also displayed on the circle.
b.
Press F2 Initialize Heads.
c. Rotate the laser and sensor. You can rotate the laser fixtures from 45°
(minimum) to 360° (maximum). Press F2 Get Sweep Data afterwards to
retrieve data from the laser fixtures.
December 2018 Quick Start Guide
Quick Start Guide 25
To Next Page
Loading...
