Configuration
[59]
CAUTION!
Sensor gain
Enter the sensor gain. See
Figure 8-24
where to find the data if
using an EZ 105x or an EZ 108x sensor. The abbreviation for the
sensor gain on the label is SG.
Figure 8-24: Location sensor data
A.
Label with sensor calibration data
B.
Label with sensor type and serial number.
Sensor offset
Enter the sensor offset. See
Figure 8-24
where to find the data if
using an EZ 105x or an EZ 108x sensor. The abbreviation for the
sensor offset on the label is SO.
Sensor
frequency
offset [Hz]
Enter the frequency offset. See
Figure 8-24
where to find the data if
using an EZ 105x or an EZ 108x sensor. The abbreviation for the
sensor frequency offset on the label is SFO.
Cable gain
Enter the gain of the extension cable. See
Figure 8-25
where to find
the data on the cable. The abbreviation for the cable gain on the
label is CG.
Figure 8-25: Location extension cable data
A.
Label with extension calibration data
B.
Label with extension cable type and serial number.
Cable
frequency
offset
Enter the frequency offset of the extension cable. See
Figure 8-25
where to find the data on the cable. The abbreviation for the cable
frequency offset on the label is CFO.
2. Click Next.
The dialog for sending the configuration opens.
3. Click Next to send the configuration to the EZ 1000.
Connections to external devices may be interrupted when sending configurations.
The output voltage of the EZ 1000 is set to > -1.5 V during this process.
To Next Page
Loading...