Maintenance, fault finding, and repair
[86]
Prerequisites
Ensure that the EZ 1000 to be updated is powered and the following items are available:
• PC or Laptop with the latest version of Machine Studio installed.
• USB cable with Type-A and micro-USB B plug
• Latest firmware file
• Suitable tool for pressing the calibration button, such as a 2 mm screw driver or a
pen.
Procedure
1. Start Machine Studio.
2. Connect the EZ 1000 converter through the USB interface to the PC.
3. Switch on the power supply of the EZ 1000, if not already done.
Machine Studio automatically establishes a connection to the EZ 1000.
4. In Machine Studio, go to the Advanced tab, and press Ctrl+Alt+M to enable the
maintenance mode.
The button for the firmware update appears.
Figure 10-2: Advanced
5. Select the EZ 1000 to be updated from the device tree.
The button for the firmware update is activated (colored).
6. Click Firmware update to open a file browser to browse to the storage location of the
firmware file.
7. Select the firmware file, and click Open.
The update process starts. The update dialog opens.
To Next Page
Loading...