1592015610 User manual IC200D EVO GB rel1.0 10.11.2015_rev10 IC200D 19/192
7. DISPLAY LAYOUT
Pushing or key it is possible to read the valure of the probes connected to the instrument.
Every probe is identified by a label (see display visualization table).
Example:
Fig.1: upper display shows outlet 1 evaporator temperature, the lower display shows Out1.
Pressing SET key is possible to read the same probe of the second circuit (if configured).
Fig.1
Fig.2: upper display shows outlet 2 evaporator temperature, the lower display shows Out2.
Pressing SET key is possible to read the same probe of the first circuit.
Fig.2
8. SET POINT VISUALIZATION
8.1 READ SET POINT VALUE
Push and release the SET key, the leds of the circuits are off and the set value is displayed.
In stand-by the bottom display shows SetC (set chiller), by pushing SET again the next label is SetH (set
heat pump ).
If the unit is running the only set displayed is related to the running mode.
8.2 MODIFY THE SET POINT
1) Push SET key for at least 3 seconds: the leds of the circuits are off and the set value is blinking.
2) Use the UP or DOWN key to modify the setpoint.
3) Push SET to confirm or wait the timeout (15seconds).
To Next Page
Loading...
