1592015610 User manual IC200D EVO GB rel1.0 10.11.2015_rev10 IC200D 51/192
Condenser fan status
Fan with proportional regulation
ON/OFF fan
11. HOW TO SWITCH ON / SWITCH OFF THE UNIT
11.1 SWITCH ON / SWITCH OFF THE ICHILL BY KEYBOARD
Push and release the key allows to start in chiller mode if CF58 =0, in heat pump if CF58 =1. When the
unit is running the corresponding led is on.
INPORTANT: To change from chiller to heat pump and viceversa the unit must be set in stand-by before
continuing.
Push and release the key allows to start in heat pump mode if CF58 =0, in chiller if CF58 =1er. When the
unit is running the corresponding led is on.
INPORTANT: To change from chiller to heat pump and viceversa the unit must be set in stand-by before
continuing.
STAND- BY ( OR UNIT OFF, NOT RUNNING)
The unit is considered in stand by when the leds and are both off. The stand-by is reached each time
the Chiller or the Heat Pump are turned off. During the stand by the user can:
Show all the probe measurements
Detect and reset the alarm events.
11.2 SWITCH ON / SWITCH OFF THE ICHILL DIGITAL INPUT
Turn on or off the unit from digital input
If a digital input is configured as remote ON/OFF:
The digital input overrides the keyboard command.
To Next Page
Loading...
