Emerson Dixell iChill IC207D - ELECTRICAL CONNECTIONS

1592015610 User manual IC200D EVO GB rel1.0 10.11.2015_rev10 IC200D 188/192
57. ELECTRICAL CONNECTIONS
The instrument is provided with:
 2 removable terminal blocks MOLEX MICROFIT 18 and 10 ways for power supply voltage / digital and
analogue inputs and modulating outputs
 1 removable terminal blocks STELVIO 6 ways for the remote keyboard connections, RS485 and LAN
 1 removable terminal blocks AMP 10 ways for the relay outputs
 5 ways connector for TTL RS485 interface outputs
Wiring cables:
DWDE15-KIT 1.5mt
DWDE30-KIT 3.0mt
Wire size:
 signal cable AWG 24
 power supply cable AWG 22
General notes:
 Check the connecitons and the line voltage before turning on the power supply.
 Keep low voltage cables, such as analogue/digital inputs/outputs and probes, away from power cables and
terminals.
Respect the maximum load current of each relay output, in case of power loads use filtered contactors.
58. ACCESSORIES
58.1 MONOPHASE FAN CONTROL: 230VAC AND CUT PHASE CONTROL
Models
XV05PK
XV10PK
XV22PK
Power
500W
1000W
2200W
Ampere
2A
4A
9.5A
Power supply
230Vac
Input
0 - 230Vac
output
-10 - 65°C
Operating temperature
Naylon supports
D
15mm
Height
Model
XV05PK
XV10PK
XW22PK
Y
25mm
42mm
64mm
Connections
A 1(+), 2(-)
PWM input control
B 3(+), 4(-)
PWM output repetition signal
F
Phase