Emerson Dixell iChill IC207D - Page 45

1592015610 User manual IC200D EVO GB rel1.0 10.11.2015_rev10 IC200D 45/192
Parameters programming with Hot Key 64
It is possible to use the HotKey 64 for:
 copy the parameter map from the HotKey 64 to the Ichill (Download)
 copy the parameter map from the Ichill to HotKey 64 (Upload)
Download from HotKey 64 to Ichill:
this operation is enabled only if the Ichill is in STD-BY or remote OFF, otherwise the display shows the
message “Download enabled only in stand-by”.
Download procedure:
 Insert the Hot Key 64 into the 5 ways connector through the hole at the top of the Ichill (see image below)
 Select “Download from HotKey to device”
 Press ENTER
 if the operation was successful the display shows “OK”, otherwise shows “ERR”
Upload from Ichill to Hot Key 64:
Upload procedure:
 Insert the Hot Key 64 into the 5 ways connector through the hole at the top of the Ichill (see image below)
 Select “Upload from device to HotKey”
 Press ENTER
 if the operation was successful the display shows “OK”, otherwise shows “ERR”
In case of Upload / Download failure:
 Hot Key 64 not properly inserted in the 5 ways connector
 Hot Key model different to Hot Key 64