Emerson EV2000 Series - Page 104

100 Appendix 1 Parameters
EV2000 Series Universal Variable Speed Drive User Manual
Group 7: Terminal Function Parameters
Para. Name LCD Display Setting Range Unit
Factory
setting
Modif
reaches
reference value
VALUE
F7.35
Terminal’s
positive and
negative logic
TERMINAL
ENABLE
STATE
Binary setting:
Positive logic: Terminal Xi is enabled if it is connected to
corresponding common terminal, and disabled if it is disconnected;
Negative logic: Terminal Xi is disabled if it is connected to
corresponding common terminal, and enabled is it is disconnected;
Unit’s place of LED: Bit0~Bit3:X1~X4
Ten’s place of LED: Bit0~Bit3:X5~X8
Hundred’s place of LED: Bit0~Bit1:FWD. REV, Bit2~Bit3:Y1. Y2
1 000
○
Group F8: Display Parameters
Para. Name LCD Display Setting Range Unit
Factory
Setting
Modif.
F8.00
Language selection
(Chinese/ English)
LANGUAGE
SELECT
0:Chinese 1:English
Note: This function is only applicable for LCD panel
1 0
○
F8.01
Parameter group 1
displayed during operation
OPR DISPLAY1
(Not flash, ▲
and ▼ keys are
valid only in
frequency and
speed displaying
status; The
status will be
saved at power
off)
Binary settings:
0:No display; 1:Display
Unit’s place of LED:
Bit0: Output frequency (Hz) (before compensation)
Bit1: Output frequency (Hz) (after compensation)
Bit2: Reference frequency (Hz flashes)
Bit3:Output current(A)
Ten’s place of LED:
Bit0:Spinning speed(R/MIN)
Bit1:Reference speed(R/MIN flashes)
Bit2: Line speed(M/S)
Bit3:Reference line speed(M/S flashes)
Hundred’s place of LED:
Bit0:Output power
Bit1:Output torque(
％)
Note: The frequency before compensation will be
displayed if all the Bits are 0.
1 3FF
○
F8.02
Parameter group 1
displayed during operation
OPR DISPLAY2
(nor flash; the
status will be
saved at power
off)
Binary settings:
0:No display; 1:Display
Unit’s place of LED:
Bit0:Output voltage(V) Bit1:Bus voltage
Bit2:VCI(V) Bit3:CCI(V)
Ten’s place of LED:
Bit0: Analog close loop feedback(%)
Bit1: Analog close loop feedback(% flashes)
Bit2: External counting value(no unit)
Bit3: Terminal status(no unit)
Hundred’s place of LED:
Bit0: Actual length Bit1: reference length
1 000
○