Emerson Fisher FIELDVUE DVC6000 - Page 156

DVC6000 Digital Valve Controllers
September 2013
Index-2
Analog Input, 5-10
Auto Calibrate Travel, 5-2
Error Messages, 5-4
Manual Calibrate Travel, 5-4
Pressure Sensors, 5-6
Relay Adjustment, 5-10
Sensor Calibration, 5-6
Pressure Sensors, 5-6
Touch−Up Travel, 5-6
Travel
Auto, 5-2
Manual, 5-4
Analog Calibration Adjust, 5-4
Digital Calibration Adjust, 5-5
Travel Sensor, 5-7
Travel Sensor Adjust, 5-7
Calibration , Travel, 5-2
Calibration and Diagnostics, 4-17
Calibration Status and Location, 4-18
Change Cutoffs
Travel Limit/Cutoff Alerts, 4-14
Travel/Pressure Control, 4-9
Change Travel Limits, Travel Limit/Cutoff
Alerts, 4-15
Classifications/Certifications, 1-6
Clear ALL Records, 4-16
Command 3, 4-3
Communication Cable Capacitance, 2-33
Connections
Electrical
4 to 20 mA Loop, 2-24
Communication, 2-29
Test, 2-29
Pneumatic
Output, 2-21
to support solenoid testing, 2-22
Supply, 2-19
Vent, 2-22
Control Mode, 4-3
Control System Requirements
Compliance Voltage, 2-32
HART Filter, 2-30
Voltage Available, 2-31
CSA
Hazardous Area Classifications, 1-6, 1-8
Loop Schematic, B-3
Loop Schematics, B-2
Nameplates, B-2, B-3
Custom Characterization, 4-11
Define , 4-11
Cutoff Hi
Travel Limit/Cutoff Alerts, 4-14
Travel/Pressure Control, 4-9
Cutoff Lo
Travel Limit/Cutoff Alerts, 4-14
Travel/Pressure Control, 4-9
Cutoffs and Limits, Travel/Pressure Control,
4-9
Cycle Counter, 4-15
Alert Point, 4-15
Displaying Value, 6-7
Enabling Alert, 4-15
Resetting, 4-15
Cycle Counter Deadband, 4-15
D
Date, 4-17, 4-18
DD Information, 6-8
Define Custom Characterization, 4-11
Description, DVC6000 Series, 1-3
Descriptor, 4-17
Detailed Setup, 4-2
Device Information, 6-8
Device Record, 6-4
Device Revision, 6-8
Digital Calibration Adjust, 5-5
DIP Switch, Setting, 7-7
Drive Signal, Displaying Value, 6-7
Dynamic Response, 4-11
E
Educational Services, 1-4
Electrical Classification, Hazardous Area, 1-6
Electromagnetic Compatibility, 1-5
End Point Pressure Control, 4-9, 4-10
EPPC Saturation Time, 4-10
EPPC Setup Point, 4-10
Error Messages, Auto Calibrate Travel, 5-4
F
Factory Default Settings, Initial Setup, 3-3
Index
G