Index
September 2013
Index-3
Factory Settings, Restoring, 5-11
Failure Group Enable, 4-16
Feedback Connection, 4-19
Firmware Revision, 6-8
FM
Hazardous Area Classifications, 1-6, 1-9
Loop Schematic, B-4
Nameplates, B-5
Special Conditions of Safe Use, 2-4
Free Time, Self Test Failure, enabling to
cause instrument shutdown, 4-12
G
Gauges, Tire Valves, & Pipe Plugs
Parts List, 8-5
Replacing, 7-7
H
Hardware Revision, 6-8
HART Communicating, (HC), 6-8
HART Filter, Part Numbers, 8-6
HART Tag, 4-17
HART Tri−Loop, Configuring DVC6000 for use
with, 2-33
Hazardous Area Approvals, 2-4
HC, (HART Communicating), 6-8
I
I/P Converter
Parts List, 8-4
Removing, 7-6
Replacing, 7-6
Replacing Filter, 7-5
IECEx
Conditions of Certification, 2-5
Hazardous Area Classifications, 1-6, 1-11
Loop Schematic, B-9
Nameplates, B-10
Input Characterization, 4-10
Input Range, 4-18
Installation, 2-3
Instrument Clock, Setting, 4-16, 4-18
Instrument Date and Time, 4-18
Instrument Level, 6-8
capabilities, 1-2
Instrument Mode, 3-2, 4-2
Instrument Serial Number, 4-17
Instrument Status, 6-4
Viewing, 6-4
Instrument Time , 4-16
Integral Action, Enable Integral Settings, 4-6
Integral Dead Zone, 4-17
Integral Enable
Pressure, 4-8
Travel, 4-6
Integral Gain
Pressure, 4-8
Travel, 4-6
Integral Limit, 4-7, 4-17
Integral Settings, 4-7
Integrator Saturation, Status, 4-17
Internal Temperature, Displaying Value, 6-7
L
Lag Time, 4-11
Lead/Lag, 4-11
typical filter settings, 4-12
Lead/Lag Set Point Filter, 4-11
Loop Current, checking, 7-15
Loop Schematic
ATEX, B-6, B-7
CSA, B-3
FM, B-4
IECEx, B-9
Loop Schematics, CSA, B-2
M
Manual Calibrate Travel, 5-4
Manual Conventions, 1-2
Manufacturer, 4-18
Maximum Output Capacity, 1-5
maximum supply pressure, 4-18
Index
G
To Next Page
Loading...
