FloBoss 107 Instruction Manual
6-14 Sensors and Transducers Revised June-2017
Figure 6-11. Analog Input
Refer to Section 7.2, Analog Input (AI) Configuration in the
ROCLINK 800 Configuration Software User Manual (for FloBoss
107) (part D30nnnnX012) for complete instructions on using these
screens to configure the AI.
6.4 Additional Technical Information
Refer to the following documents (available at
www.EmersonProcess.com/Remote) for additional and most-
current information on each of the modules discussed in this
chapter.
Table 5-5. Additional Technical Information
To Next Page
Loading...
