Emerson FloBoss 107 User Manual

FloBoss 107 Instruction Manual
2-18 Installation and Use Revised June-2017
During operation, you can monitor the FB107 to view or retrieve current
and historical data either locally or remotely. You accomplish local
monitoring using ROCLINK 800 on a PC connected through the LOI
port. You accomplish remote monitoring by using ROCLINK 800
connected through the COM1 through COM3 ports.
The FB107 has a number of software settings (parameters) which you
must configure (using ROCLINK 800 on a PC) before the unit is
calibrated and placed into operation. Normally, the PC is connected to the
LOI port of the FB107 to transfer configuration data into the FB107,
although you can perform much of the configuration off-line and later
load it into the FB107.
The FB107 firmware provides default values for all parameters. If the
default values are acceptable for your application, leave the device as it
was delivered from the factory.

Emerson FloBoss 107 Specifications

General

Brand	Emerson
Model	FloBoss 107
Category	Controller
Language	English