[] Initial Setup
Thissectionwill guideyouthroughtheunit'sinitialsettingwhichincludes
selectingalanguageforyouron-screenmenuandautochannelscan,
whichautomaticallyscansandmemorizesviewablechannels.
Beforeyoubegin:
Makesureiftheunitisconnectedtoantennaorcables.
After making all the necessary connections, press
[POWER] to turn on the unit.
POWER
• This operation may take a few moments.
2 Use [Cursor A/T] to select the on-screen language
from the choices on the right side of the -IV screen.
(English / Espafiol / Franqais)
or
Note:
• Ifyou connect the cable system directly, contact the CATV
installer.
• Ifyou press[POWER]or [SETUP]during auto channel
scan, this setting will be canceled.
• Theinitial auto channel scan function can be executed
for either "Air" or "Cable"only once. Whenyou change the
connection (Air/Cable), set auto channel scan again. (Refer
to page 13.)
• Youcan cancel or exit the initial auto channel scanmenu
by pressing [SETUP].
• Ifthereisnosignalinputfrom theantenna terminaland
no operation for several secondsafter you turn on the unit,
"Helpful Hints" appears. Follow the instructions listed on
the TVscreen.
• "Initial Setup" menu on step 3 will be displayed in the
selected language after you press [ENTER]
3 Use [Cursor AIr] to select"Air" for-IV channels or
"Cable" for CATV channels, then press [ENTER].
or
• Scanning and memorizing of channels start
automatically.
• When the scanning and memorizing of channels are
completed, the lowest memorized channel will be
displayed.
EN
To Next Page
Loading...
Need help?
General
