[] Channel Selection
Selectchannelsbypressing[CH•/V] or[the Numberbuttons].
[] Volume Adjustment
Thissectiondescribeshowto adjustthevolume.Themutefunction,which
turnsthesoundoffandon, isalsodescribed..............................
• To select the memorized channels, use [CH •IV] or
[the Number buttons].
• To select the non-memorized channels, use
[the Number buttons].
To Use [the Number buttons]
- When selecting analog channel 12
- When selecting digital channel 12-1
Be sure to press [-] before entering the minor
channel number.
• Press [CH. RECALL] to return to the previously
viewed channel.
A bout digital TV broadcasting:
With its high definition broadcast, digital broadcasting
far surpasses analog broadcasting in both its picture
and sound quality.
What is the minor channel?
By using high compression technology, digital
broadcasting offers a service that enables multiple
signals to send simultaneously.
Therefore, you can select more than one program per
major channel since digital broadcasting technology
distinguishes between multiple channels broadcast by
a single network.
NTSC(analog mode) [AirTime] ATSC(digital mode)
18:00
18:30
19:00
19:30
20:00
20:30
L j J
major c I minor channel
: change automatically
_> :change manually by using [CH •/V]
Note:
• "No Signal'willappearon the TVscreen after the minor
channel broadcast is over.
• "Audio onlyprogram" message will appear on the TV
screen,when you receiveonly sound signal
Use [VOL. &/T] to adjust the audio volume.
• The volume bar will be displayed atthe bottom of
the TV screen when adjusting the volume.
• The volume bar will automatically disappear in a few
seconds.
Press [MUTE D_] to turn offand on the sound.
_4iJ_ ¸_i
• "Mute" is displayed on the TV screen for a few
seconds.
Press [MUTE D_] again or [VOL• _/_] to recover the
original volume.
!ii!¸
i::!
il.................
[] Sleep Timer
Thesleeptimercanbesettoautomaticallyturnofftheunit afteran
!
incrementalperiodoftime.
Press [SLEEP] to set the sleep timer. ............
• Sleep timer display appears on the TV screen.
2 Press [SLEEPI repeatedly to change the amount of time
until shut off.
i
• You can setyour unit to turn offafter a set period of
time (from 30 to 120 minutes).
• Each press of [SLEEP] will increase the time by 30
minutes.
• After setup, the sleep timer display can be called up
for checking by pressing [SLEEP].
ToCancel the Sleep Timer
Press [SLEEP] repeatedly until "Sleep Off" is displayed
on the TV screen.
Note:
• Thesleep timer display will automatically disappear in a
few seconds.
• Whenyoudisconnecttheunitfrom theACoutletorwhen
apower failure occurs, the sleep timer setting will be
canceled.
EN
To Next Page
Loading...
Need help?
General
