Antenna Confirmation
Thisfunctionletsy0ucheckthe digitalsignalstrength0feachchannel.
Press [SETUP] to display the main menu.
2 Use [Cursor A/V] to select"CHANNEL", then press
[ENTER].
or
3 Use [Cursor A/V] to select"Antenna", then press
[ENTER].
or
Use [the Number buttons] or [CH &IV] to select the
channel for which you want to check the digital signal
strength.
@@@
@@@
@@@
or
• If the channel is set to analog channel or external
input, you cannot confirm the antenna condition.
5 Press [SETUP] to exit.
EN
To Next Page
Loading...
Need help?
General
