Emerson Liebert PEX Series - Setting 485 Communication Card

Chapter 6 Application Of INTELLISLOT 77
6.3.2 Setting 485 Communication Card
Set the parameters of the 485 communication card according to the following procedures:
1. After the HyperTerminal is set, you can click
OK to display the following HyperTerminal interface.
2. Type ‘1’ and the following figure will appear.
3. Type ‘1’ and the following figure will appear.
4. Type ‘1’ and select the Modbus protocol, and the following figure will appear.
5. Type ‘3’ and select the ID used to communicate between the communication card and the host, and the following
figure will appear.
Liebert.PEX2 Series Air Conditioner User Manual