82 Chapter 6 Application Of INTELLISLOT
3. Click Access under SNMP at the left side of the interface, as shown in Figure 6-11. Type the user name ‘Liebert’
and the password ‘Liebert’, and click
OK to enter the configuration interface.
Note
The user name and password are case-sensitive.
Password
Username
OK Cancel
Connect to
Figure 6-11 Typing user name and password
4. Configure the Network Management System (NMS) of the host monitoring center in Figure 6-12. Click Edit and type
the IP address of the NMS in
IP Address. Select read or write, type ‘Public’ in Community and then click Save.
Note
1. Before setting the NMS, the Edit button is displayed on the interface. After the configuration is edited, the Edit button will
become the Save button.
2. After the NMS is configured, you must click Save to save the configuration.
Figure 6-12 NMS configuration interface of SNMP host monitoring center (1)
Liebert.PEX2 Series Air Conditioner User Manual
To Next Page
Loading...
