Components of a 4-wire remote mount transmitter (stainless steel
housing)
Figure 5-2:
A. Transmitter
B. Mounting bracket
C. Cap screws
D. End-cap
2. Attach the mounting bracket to the wall.
5.1.2 Mount the transmitter to an instrument pole
Prerequisites
• Use two 5/16-inch U-bolts for 2-inch pipe, and four matching nuts, that can
withstand the process environment. Micro Motion does not supply U-bolts or nuts
(appropriate bolts and nuts are available as an option).
• Ensure the instrument pole extends at least 12 inches (305 mm) from a rigid base,
and is no more than 2 inches (50.8 mm) in diameter.
Mounting and sensor wiring for remote core processor with remote sensor installations
50 Micro Motion
®
Model 1700 and 2700
To Next Page
Loading...
