Note
For information on the Micro Motion Ethernet Config Tool user interface, see the
Anybus Communicator manual.
Related concepts
Micro Motion Ethernet Config Tool installation (optional)
2.6 Configure the EtherNet/IP Module
Procedure
1. From your browser, login to the EtherNet/IP Module as user admin.
2. CAUTION
Wait for the web pages to automatically configure the EtherNet/IP Module.
Use the Device Configuration page to configure the EtherNet/IP Module.
3. Set up I/O at your Ethernet host.
• If you are not using RSLogix, use your standard method. For information on the
I/O assemblies, see I/O data.
• If you are using RSLogix, select ETHERNET-MODULE - Generic Ethernet Module
and enter the required information.
Installation
User Guide
January 2019 MMI-20019808
14 Micro Motion EtherNet/IP Module
To Next Page
Loading...
