Quick Panel Operator User Manual Appendix A
GFK-2847AA Jan 2023
Product Certifications and Installation Guidelines 97
Appendix A Product Certifications and
Installation Guidelines
The QuickPanel
+
Operator Interface is intended for use in industrial
environments and, when properly installed, shall comply with the agency
approvals listed in this document.
A-1 Agency Approvals
Note: The agency approvals listed in the following table and on the Declaration of Conformities are
believed to be accurate; however, the product’s agency approvals should be verified by the marking
on the unit itself.
N.A. Safety for Programmable Controller for
use in Hazardous Locations
Class I Division 2 Groups A, B, C, D
(applicable to 7'', 10'', 12'', and 15” Display
units)
Class I Division 2 Groups A, B, C, D;
Class 2 Division 2 Groups F, G;
Class 3 Division 1 and Division 2
(applicable to 6'' Display unit only)
Certification by Underwriter's Laboratories
to
UL 61010-1; UL61010-2-201;
CSA C22.2 No 142 – M1987;
CSA 61010-1; CSA 61010-2-201
ISA 12.12.01 standard and
CSA C22.2 No 213-M1987
Explosive Atmospheres Directive European
Safety for Hazardous Areas
Equipment Group II, Category 3,
Gas Groups IIC,
Dust Group IIIC
Certification in accordance with the ATEX
Directive 14/34/EU with an Independent 3rd
Party Assessment Certificate
only applies to the 12” and 15” Display units:
EN 60079-0/A11, EN 60079-15, and EN
60079-31;
Part numbers: IC755CSW07CDACA,
IC755CSS10CDACA, IC755CSS12CDBCA,
IC755CSS15CDACA
Electromagnetic Compatibility Directive
European Electromagnetic Compatibility
(EMC) for Industrial Control Equipment
Self-declaration in accordance with
European Directives
EN61000-6-2, EN61000-6-4
Maritime Society Certification
No Marking,
verified by a
certificate
American Bureau of Shipping (ABS),
Det Nortske Veritas/Germanischer Lloyds
(DNV-GL), and Bureau Veritas (BV)
certification on conformally coated
6”, 7”, 10”, 12”, 15” units only
To Next Page
Loading...
