Procedure
1. Review the information under the Flow Configuration and
Device Configuration headings.
Note
For more information, see Verifying device configuration.
Figure 7-7: Save/Send Configuration Tab
2. Select the icon above each window to edit the configuration
information in these windows.
Note
The user will be notified if the configuration has been modified
since it was last sent to the transmitter. A warning message
will be shown to the right of the Send Flow Data and/or Send
Transmitter Data checkboxes.
3. To send the configuration, select the Send To button.
Note
The Send Flow Data and Send Transmitter Data checkboxes
can be used to select what configuration data is sent
to the transmitter. If either checkbox is unselected, the
corresponding data will not be sent.
Quick Start Guide January2024
30 Emerson.com/Rosemount
To Next Page
Loading...
